#Nissan data scan 2 idle air volume learn how to Pc#
#Nissan data scan 2 idle air volume learn how to plus#

#Nissan data scan 2 idle air volume learn how to Pc#

If BluetoothВ® signal waves are within range of the CONSULT PC and the VI during reprogramming, reprogramming may be interrupted and the ECM/TCM may be damaged.ДҐ.Turn the ignition ON with the engine OFF or вЂњnot readyвЂќ. If the battery voltage goes out of this rangeД¤.Turn off all external BluetoothВ® devices (e.g., cell phones, printers, etc.) within range of the CONSULT PC and the VI.Д¬AUTION: Make sure to turn off all external BluetoothВ® devices. Make sure the battery voltage stays between 12.0V and 15.5V during reprogramming. Make sure to connect the GR-8 securely to the 12V battery. Use the GR-8 вЂ“Battery and Electrical Diagnostic Station.Д¬AUTION :В DO NOT use a standard battery charger for Hybrid vehicles.If the battery voltage goes out of this range during reprogramming, the ECM/TCM may be damaged. NOTE: The GR-8 (Battery and Electrical Diagnostic Station) set to вЂњPower SupplyвЂќВ mode is recommended.Д¬AUTION:В Be sure the battery charger is connected securely to the battery. Set the battery charger at a low charge rate. If the CONSULT PC battery voltage drops during reprogramming, the process will be interrupted and the ECM/TCM may be damaged.ДЈ.Connect a battery charger to the vehicle battery:

#Nissan data scan 2 idle air volume learn how to plus#

If the plus VI connection is loose during reprogramming, the process will be interrupted and the ECM/TCM may be damaged.Дў.Connect the AC Adapter to the CONSULT PC.Д¬AUTION:В Be sure to connect the AC Adapter. Make sure to use the correct VI for C-III plus (plus VI).Д¬AUTION:В Make sure the plus VI is securly connected. The abve conditions are required for the IAVL to complete.ДЎ.Connect the plus Vehicle Interface (plus VI) to the vehicle.After reprogramming is complete, you will be required to perform Throttle Valve Closed Position, Idle Air Volume Learn (IAVL), Accelerator Closed Position, and DTC erase.Hybrid only: Li-ion battery charging status: 50% or moreД®ngine coolant temperature: 70 вЂ“В 100вЊ (158 вЂ“В 212вЏ)Д«attery voltage: More than 12.9V (At idle) For conventional and hybrid vehicles if reprogramming the ECM, take the vehicle for a 10 minute drive in order to meet the following conditions: